![]()
Best option for wireless adapter for mac os 10.5 software#On the System Info page under Bluetooth I see Bluetooth software 2.0 and firmware version 3.1965. Best option for wireless adapter for mac os 10.5 drivers#It seems that Microsoft is now better at writing drivers than Apple is. ![]() Best option for wireless adapter for mac os 10.5 pro#I have read from many people that rebooting the same MacBook Pro under Windows in Boot Camp doesn't exhibit any Bluetooth problem. Best option for wireless adapter for mac os 10.5 driver#It would seem from what I read that Apple did change the Bluetooth hardware in the late 2008 MacBook Pros and MacBook Air and the Bluetooth driver in Leopard are screwed up or, in other words, a piece of junk. This headset used to work just fine on my previous MacBook Pro, even under Leopard, but right now, there is a very serious distortion problem that makes using the headphone well, unusable again. Today, I just tried using my Plantronics 590 headset as headphones on it. It seems to work but the network speed is simply abysmal. My Samsung Blackjack Windows Mobile 5 phone which used to provide internet access to my previous MacBook Pro (2006) under Tiger is now completely unusable under Leopard on my new MacBook Pro (late 2008). But if there are lots of lost packets and there isn't enough room for retransmits, you'll start noticing cut-outs, or even complete loss of sound.ĭisclaimer: I work for Wi-Gear, makers of the iMuffsĪfter some research on this, it seems that there is a serious problem with Bluetooth in 10.5 on late 2008 MacBook Pro and MacBook Air. There's enough bandwidth for stereo Bluetooth and a Bluetooth mouse at the same time. But in addition to that minimum bandwidth, if there is any interference and a packet is lost, it uses a little extra bandwidth to retransmit the packet so you never notice. It's got a 1mbps limit and the stereo profile needs between 200 and 350kbps depending on the quality of the compression the transmitter chooses. There are very few stereo Bluetooth headphones out there that support EDR.īTW, there is enough bandwidth in regular Bluetooth 1.2 and 2.0 to handle stereo streaming. And furthermore, even if your Mac supports EDR, the device on the other end needs to support it as well in order to get any benefits. In particular, if you have an older Mac and get Leopard, you may not get EDR speed. It saves me having to use the bulky audio jack adapter with my headphones, though.ĭespite what Wikipedia says about Bluetooth 2.0+EDR, it should be pointed out that EDR is an optional part of the Bluetooth 2.0 spec, so just because a device says it can do 2.0 does not mean it gets any of the speed benefits of EDR. So it's not perfect, although I'm hoping both of these issue have simple solutions. The second is more minor: at least on my headphones, the stereo is reversed, so I've taken to wearing them backwards until I can find a solution. If I disconnect one of these devices, the problem vanishes. My keyboard sometimes loses its connection when audio is playing, and audio likewise sometimes cut out momentarily. The big one is that there seems to be a bit of a problem with my Apple Bluetooth keyboard and my Bluetooth headphones interfering with each other (or using too much Bluetooth bandwidth, or something). I have encountered a couple glitches so far. However, with my headphones, the back and forward buttons do advance iTunes back and forward through the song list, just as it should. ![]() I have not yet found any way to specifically configure this feature (for example, to remap controls). For example, I can use the built-in controls on my headphones to control iTunes. In addition, Leopard supports the AVRCP profile, which allows for remote control functions to be used on audio devices. Best option for wireless adapter for mac os 10.5 full#Leopard creates two audio devices after pairing, one of which is labeled "headset" and uses the headset profile, the other is labeled "headphones" and uses full A2DP Stereo. I successfully paired my Plantronics Bluetooth headphones with my MacBook in Leopard. In previous versions of the Mac OS, the only Bluetooth audio profile supported was headset, limiting output to low data-rate mono sound. This profile allows for the transfer of high-quality stereo audio over Bluetooth. Leopard supports the A2DP Bluetooth profile. There is absolutely no trick to using this feature in Leopard, but it is new and undocumented in the 300 features that Apple lists, so I thought I ought to mention it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |